Tri-Heal (45mg) Dosage Protocol
A targeted blend integrating TB-500 (15mg), BPC-157 (15mg), and KPV (15mg) for coordinated support in inflammation control, recovery pathways, and structural balance.
Add 2.0 mL bacteriostatic water → 22.5 mg/mL concentration
300-600 mcg once daily
At 22.5 mg/mL, 1 unit = 0.01 mL ≈ 225 mcg
Lyophilized: freeze at −20°C; reconstituted: refrigerate at 2–8°C
| Week | Daily Dose | Units (per injection) |
|---|---|---|
| Weeks 1-2 | 300 mcg | 1.3 units (0.013 mL) |
| Weeks 3-4 | 450 mcg | 2 units (0.02 mL) |
| Weeks 5-8+ | 600 mcg | 2.7 units (0.027 mL) |
- 1Draw 2.0 mL bacteriostatic water with a sterile syringe
- 2Inject slowly down the vial wall; avoid foaming
- 3Gently swirl/roll until dissolved (do not shake)
- 4Label and refrigerate at 2–8°C, protected from light
Tri-Heal combines TB-500 for tissue repair and angiogenesis, BPC-157 for gut and tissue healing through nitric oxide modulation, and KPV (alpha-MSH fragment) for potent anti-inflammatory support through NF-κB pathway modulation.
- Supports inflammation management
- Promotes tissue repair and recovery
- May support gut health and integrity
- Demonstrates cytoprotective properties
- KPV anti-inflammatory research studies
- BPC-157 gastrointestinal protection studies
- TB-500 tissue repair clinical trials
Lyophilized
Store at −20°C in dry, dark conditions
Reconstituted
Refrigerate at 2–8°C; avoid freeze-thaw cycles
Allow vials to reach room temperature before opening
- •Use new sterile insulin syringes for each injection
- •Rotate injection sites to reduce local irritation
- •Document daily dose and site rotation
- •This is for research purposes only
Disclaimer: This content is intended for research and educational purposes only. Not intended to diagnose, treat, cure, or prevent any disease. All compounds are for research use only. Dosing information is derived from published scientific literature and clinical studies.